Selecting and Using the Most Appropriate Car Safety Seats for Growing Children: Guidelines for Counseling Parents (AAP)

Abstract

Despite the existence of laws in all 50 states requiring the use of car safety seats or child restraint devices for young children, more children are still killed as passengers in car crashes than from any other type of injury. Pediatricians and other health care professionals need to provide up-to-date, appropriate information for parents regarding car safety seat choices and proper use. Although the American Academy of Pediatrics is not a testing or standard-setting organization, this policy statement discusses the Academy’s current recommendations based on the peer-reviewed literature available at the time of publication and sets forth some of the factors that parents should consider before selecting and using a car safety seat.

INTRODUCTION

In 2000, 539 children younger than 5 years died while riding in motor vehicles; almost half were unrestrained, and many others were restrained improperly. Many parents want to know which car safety seat is best for their child. An appropriate car safety seat is the right size for the child, fits the vehicle’s seats and seat belt systems, and is easy for parents to use properly. In addition, it must meet all applicable federal safety standards.

Pediatricians also need to be aware that the child occupant protection laws in their states may not reflect the safest way to transport a child. Parents should be counseled to follow the American Academy of Pediatrics (AAP) recommendations for best child passenger restraint, and pediatricians should advocate to improve their state laws to provide better child protection.

AAP RECOMMENDATIONS

Seat Selection

Children should face the rear of the vehicle until they are at least 1 year of age and weigh at least 20 lb to decrease the risk of cervical spine injury in the event of a crash. Infants who weigh 20 lb before 1 year of age should ride rear facing in a convertible seat or infant seat approved for higher weights until at least 1 year of age. If a car safety seat accommodates children rear facing to higher weights, for optimal protection, the child should remain rear facing until reaching the maximum weight for the car safety seat, as long as the top of the head is below the top of the seat back.
Premature and small infants should not be placed in car safety seats with shields, abdominal pads, or arm rests that could directly contact an infant’s face or neck during an impact and injure the child.
For optimal protection, pediatricians should counsel parents of most children (those who weigh more than 12 lb at 4 months of age) to encourage use of a convertible car safety seat that will accommodate them rear facing at higher weights.
A convertible car safety seat is positioned semi-reclined and rear facing for a child until at least 1 year of age and at least 20 lb. The seat is positioned upright and forward facing for an older and heavier child who weighs up to 40 lb and may be used as long as the child fits well (eg, tops of ears below the top of the car safety seat back and shoulders below the seat strap slots).
A forward-facing seat, a combination seat, or a belt-positioning booster seat should be used when the child has outgrown a convertible safety seat but is too small to use the vehicle’s safety belts. Vehicle safety belts should not be used until the shoulder belt can be positioned across the chest with the lap belt low and snug across the thighs; the child should fit against the vehicle’s seat back with his or her feet hanging down when the legs are bent at the knees. A belt-positioning booster seat should be used until the vehicle safety belt fits well.
Many new vehicles are equipped with integrated (built-in) car safety seats that are designed for forward-facing riders who are at least 1 year of age and weigh at least 20 lb. All younger infants should be positioned rear facing in separate car safety seats until they are at least 1 year of age and weigh at least 20 lb. When purchasing a new vehicle, parents should consider selecting a vehicle with an optional integrated car safety seat. Some integrated seats convert to booster seats for older children.
On the basis of Federal Motor Vehicle Safety Standards established by the National Highway Traffic Safety Administration (NHTSA), shield boosters have not been certified by their manufacturers for use by children who weigh more than 40 lb. In current models, the shield can be removed and the restraint can be used with a lap and shoulder belt as a belt-positioning booster seat for children who are too heavy or tall to fit in a seat with a full harness.

Children who weigh 40 lb or less are best protected in a seat with a full harness. Significant injuries to the head, spine, abdomen, and extremities of children in shield boosters have been documented in crash investigations resulting from ejection, excessive head excursion, and shield contact. Although boosters with shields may meet current Federal Motor Vehicle Safety Standards for use by children who weigh 30 to 40 lb, on the basis of current published peer-reviewed literature, the AAP does not recommend their use.
A number of aftermarket add-on devices claim to solve the problem of poorly fitting seat belts; however, these products may actually interfere with proper lap and shoulder harness fit by positioning the lap belt too high on the abdomen and allowing too much slack in the shoulder harness, placing it too low across the shoulder. Until performance requirements are developed by the NHTSA for aftermarket devices, these products should not be used.
Children with special health care needs should have access to appropriate restraint systems. Specific information is available in the AAP policy statement “Transporting Children with Special Health Care Needs”and “Safe Transportation of Children With Special Needs: A Guide for Families.”

Installation in Vehicle

A rear-facing car safety seat must not be placed in the front passenger seat of any vehicle equipped with an air bag on the front passenger side. Death or serious injury to an infant can occur from the impact of the air bag against the back of the car safety seat.
Parents should be advised that the rear vehicle seat is the safest place for children of any age to ride. Any front-seat, front-facing passengers should ride properly restrained and positioned as far back as possible from the front air bag on the passenger side.
Parents should be instructed to read the vehicle owner’s manual and child restraint device instructions carefully. When the car safety seat is installed in the car, it should be tested for a safe, snug fit in the vehicle to avoid potentially life-threatening incompatibility problems between the design of the car safety seat, vehicle seat, and seat belt system.

Lower Anchors and Tethers for Children (LATCH) is a new standardized car safety seat attachment system that will simplify car safety seat installation and enhance safety. Most new vehicles and car safety seats will be equipped with this system by September 2002.
Infants should ride at approximately a 45° angle to prevent slumping and airway obstruction. If the vehicle seat slopes so that the infant’s head flops forward, the car safety seat should be positioned back at an approximately 45° tilt according to the manufacturer’s instructions. Some car safety seats have built-in features that allow adjustment of the angle. For car safety seats that do not adjust, a firm roll of cloth, a solid-core Styrofoam roll, or a tightly-rolled newspaper can be wedged under the car safety seat below the infant’s feet to achieve this angle.
Experience with the interaction of vehicle side air bags and car safety seats is limited. To date, no crash studies have established that a child properly restrained in a car safety seat is at risk from current side air bag impact. Laboratory simulations have indicated, however, that unrestrained and out-of-position children are at risk of serious injury from a deploying side air bag.Because children cannot be depended on to remain in position at all times and until additional research and experience is acquired, parents should be counseled about the potential risks and benefits of having side air bags. Parents should consider placing children and car safety seats away from all air bags, choosing a vehicle without side air bags in the rear seat, or deactivating side air bags in rear seats if children are transported in adjacent positions. They may also refer to the vehicle owner’s manual for recommendations specific to their vehicle.

Placement of Child in Seat

In rear-facing car safety seats for infants, shoulder harnesses usually should be placed in the slots at or below the infant’s shoulders, the harness should be snug, and the car safety seat’s retainer clip should be positioned at the level of the infant’s armpit, not on the abdomen or in the neck area (see manufacturers’ instructions for details).
In forward-facing car safety seats for older children, the shoulder strap should be at or above the child’s shoulders, the harness should be snug, and the retainer clip should be positioned level with the child’s armpits. This seat should be used until the child reaches the top weight limit of the seat or the tops of his or her ears reach the top of the car safety seat back (see manufacturers’ instructions for details).
A child should never be left unattended in a car safety seat in or out of the car.

Fig 1.

Car safety seats: selecting the appropriate type.

SUMMARY

Existing products provide effective restraint for children riding in motor vehicles and minimize risk of death and injury during car crashes if used appropriately. Parents look to pediatricians for up-to-date, accurate information on selecting and properly using car safety seats. New products that address gaps in restraint protection are continually being developed. Manufacturers should be encouraged to develop car safety seats that accommodate children rear facing to 4 years of age (45 lb). It is important that pediatricians keep abreast of innovations in child passenger safety.The use of the AAP materials, including “Car Safety Seats: A Guide for Families,” the “One-Minute Car Seat Safety Check-Up,”and “Safe Transportation of Children With Special Needs: A Guide for Families” can assist the physician in providing specific advice for patients. The information in Fig 1 in this statement will also aid in selecting the appropriate type of restraint. Additional consultation for detailed technical information can be obtained from certified child passenger safety technicians identified by state on the NHTSA Web site (http://www.nhtsa.dot.gov/people/injury/childps/contacts/index.cfm). This information will help parents ensure that their children are transported as safely as possible.

ref: http://pediatrics.aappublications.org/content/109/3/550.full?sid=c7c66e68-47d0-4420-a2a7-674f08bac2ca

If your baby goes to be motion associate degree exceedingly automobile she should have an applicable seat for her age and one that's fitted properly. we tend to show you ways to suit a baby seat.

If your baby goes to travel in an exceedingly automobile, by law she should have Associate in Nursing applicable seat.

For a newborn you will need 0+ kid carrier (suitable from birth to once your baby weighs 13kg -- around 12-15 months) or a mixture group 0/1 seat, that lasts from birth to 18kg (around age four).

Baby automobile seats have evolved in recent years, with bolder styles and new options adding to their skillfulness. several will currently be connected to a compatible pusher to make a travel system. alternative seats lie flat so that they double as carrycots.

The priority with all automobile seats is safety, therefore check the seat are going to be secure in your automobile. 'Some makers list compatible vehicles on their website; otherwise the employee ought to be ready to check,' says Carolean Cosgrove of nursery consulting service Baby caretaker.

It's also crucial that you simply shrewdness to put in the seat, therefore evoke an indication.

While commonplace automobile seats attach exploitation the adult safety belt, ISOFIX models clip onto a base that plugs into the car's chassis, simplifying installation.

ref: http://www.youtube.com/watch?v=Ns4fSnsm2P8